Stovax 705088 Bedienungsanleitung

Clarendon & AshdonLog Effect Stove RangeConventional FlueWith upgradeable control valveInstructions for Use,Installation and ServicingFor use in G

10IMPORTANT: ENSURE THAT THE APPLIANCE ISCORRECTLY ADJUSTED FOR THE GAS TYPE ANDCATEGORY APPLICABLE IN THE COUNTRY OF USE.REFER TO DATABADGE AND TECHN

113.6 The flue system may now be connected to the stove. Ensurethat all joints are sealed with a suitable fire resistant sealant.It is also recommende

125.4 Place log D across from the rear log A to log B on the left-hand side. There are cut-outs in both logs for location. Seediagram 6.5.5 There are

136. LIGHTING6.1 Full instructions are given in the User section under Lightingthe Stove.INSTALLATION INSTRUCTIONSINSTALLATION

1. COMMISSIONING1.1 Close all openable doors and windows in the room, ignitethe stove and operate on maximum for 10 minutes. Positiona lighted smoke

151. SERVICING REQUIREMENTSThis appliance must be serviced at least once a year by acompetent person.All tests must be serviced by best practice as de

16SERVICING INSTRUCTIONSSERVICING / FAULT FINDING CHARTSNO SPARKIGNITION FUNCTIONAL CHECK 2Ensure there is no debris around the pilot assembly, (e.g.

17SERVICING INSTRUCTIONSREPLACING PARTS1. GENERAL1.1 All principal components can be replaced without removingthe stove from its installation, althou

18SERVICING INSTRUCTIONSREPLACING PARTS3.7 To remove the thermocouple, undo the retaining nut andwithdraw the thermocouple. Undo the thermocouple fro

19SERVICING INSTRUCTIONSREPLACING PARTS6.6 Check all joints for gas leaks. Check the operation of thethermocouple and ignition lead. 7. MAGNETIC SAFE

2CONTENTSCOVERING THE FOLLOWING MODELSCLARENDON – 8611LUC – P8611LUC / 8612LUC – P8612LUCASHDON – 8613LUC – P8613LUC / 8614LUC – P 8614LUCPAGEAPPLIANC

20SERVICING INSTRUCTIONSREPLACING PARTS9.3 Undo the two screws at the back of the firebox and carefullywithdraw the bracket.9.4 Disconnect the two sl

21SERVICING INSTRUCTIONSREPLACING PARTS11. CHANGING BETWEEN GAS TYPESIn order to change between gas types, it will be necessary tochange the following

22SERVICE RECORDS1ST SERVICEDate of Service:...Next Service Due:...

Gazco Limited, Osprey Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7JGTel: (01392) 261999 Fax: (01392) 444148 E-mail: [email protected]

3FLUE CHECK PASS FAIL1. Flue is correct for appliance2. Flue flow test3. Spillage testGAS CHECK1. Gas soundness & let by test2. Standing pressure

4USER INSTRUCTIONS1. GENERAL1.1 Installation and servicing must be carried out by acompetent person in accordance with Gas Safety (Installationand Use

6. CLEANING THE FIREWARNING: DO NOT ATTEMPT TO CLEAN THE STOVEUNTIL IN A COLD CONDITION. THE STOVE RETAINSITS HEAT FOR A CONSIDERABLE TIME AFTERSHUTDO

67.2 Place log B on the left-hand side of the burner with thelocation bar on the underside of the log fully located in thelong slot of the burner. Mak

7.8 Carefully insert the front coal retainer into the front panel ofthe firebox. Take care not the scrape/damage the logs. Thiscoal retainer sits in t

8INSTALLATION INSTRUCTIONSTECHNICAL SPECIFICATIONCOVERING THE FOLLOWING MODELS:CLARENDON – 8611LUC – P8611LUC / 8612LUC – P8612LUCASHDON – 8613LUC – P

9INSTALLATION INSTRUCTIONSSITE REQUIREMENTS1. FLUE AND CHIMNEY REQUIREMENTS1.1 The chimney or flue system must comply with the rules inforce and must